IBM Power System S822LC Manual page 30

11. Secure the cold plate to its corresponding plastic holder, and then attach the holder to the carrier.
a. Pivot the holder up. Pinch in at the sides to remove the holder from the carrier as shown in
Figure 17.
Figure 17. Removing holder from carrier
b. Slide one cold plate pin into the holder as shown (A) in Figure 18. Push the pin into the slot only
as far as is needed.
Figure 18. Inserting the cold plate pins into the holder
c. Pivot the cold plate to slide the other pin into the holder as shown in (B) in Figure 18. Push the
pin into the slot only as far as is needed.
d. Pinch the holder at the sides (B) as shown in Figure 19 on page 15 and replace it onto the carrier.
14
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)