Replacing A Disk Drive From The 8335-Gtb System - IBM Power System S822LC Manual

Figure 47. Disk drive lock detail
5. Support the bottom of the drive as you slide it out of the system. Do not hold the drive by the
handle.
6. If you are removing more than one drive, repeat the steps in this procedure until all drives are
removed.

Replacing a disk drive from the 8335-GTB system

Follow these steps to replace a disk drive in the IBM Power System S822LC (8335-GTB) system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Hold the drive by the top and bottom edges as you position the drive, and insert it into the drive slot.
Important: Ensure that the drive is fully seated and is all the way into the system.
3. Lock the drive bay handle (A) by pushing in the handle release. See Figure 48 on page 38.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
37