IBM Power System S822LC Manual page 172

Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
2. Open the packaging of the new system processor module, and place the cover upside down next to
the tray, as shown in Figure 179. The cover is used for the system processor module that you are
replacing.
Figure 179. Opening the system processor module packaging
3. Remove the cold plate from the system processor module.
a. Loosen the cold plate retainer screw by turning the supplied hex key counterclockwise as shown
in Figure 180 on page 157. Loosen the screw until it moves freely.
156
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)