Quilting Frame Levelling - Bernina Q 24 Manual

Quilting frame assembly
> Position the metal brackets (M10) so that two tabletops rest on each bracket. Tighten the screws (see
> Place the tabletops onto the metal brackets (M10) so that the tabletops are stable.
> If necessary, carefully undo the metal brackets (M10) and reposition them.

2.8 Quilting frame levelling

To allow the machine to move smoothly on the quilting frame, the quilting frame must be aligned perfectly
horizontally using the levelling feet after assembly.
Required parts and tools:
• Open-ended wrench no. 17 (T2)
• Spirit level (not included in the scope of delivery)
> Move the quilting frame into the final position for quilting.
> Screw in the levelling feet (M1) on the central leg until they no longer touch the floor.
> Use the spirit level to check the horizontal alignment of the quilting frame. If necessary, shorten the
> As soon as the quilting frame has been levelled, unscrew the levelling feet (M1) on the central leg so that
26
page 13).
lateral leg lengths by screwing in the levelling feet (M1) or extend them by unscrewing the feet.
they touch the ground firmly and the quilting frame is well supported.