Appendix
5
5.1 Differing information for the "Large" quilting frame
Overview of large parts (see page 7)
5x tabletops: 3× large, 2× small
Overview of small parts (see page 8)
• 12x metal brackets (M10)
• 16x felt strips (M11)
• 12x countersunk screws M8x14 (S8)
Attaching tabletop brackets (see page 25)
> Fit the 12 metal brackets (M10) with 12 countersunk screws M8x14 (S8).
Positioning tabletops (see page 25)
> Attach the 16 felt strips (M11).
> Position three large tabletops in the center, with one small tabletop each on the right and the left.
Attaching the leaders (see page 55), (see page 56), (see page 57)
In the step entitled «Measure and then use a pencil to mark out a point 155 cm/61 inches to the left and the
right of the marked center.», use the following values: 170 cm/67 inches
5.2 Differing information for the "Small" quilting frame
General overview (see page 6)
Point 16 «Legs, center» is no longer applicable.
Overview of large parts (see page 7)
Just two legs, on the right and the left
Overview of small parts (see page 8)
• 12× head cap screws M4×16 (S6)
• 2× head cap screws M8 × 50 (S2)
• 4× slot nuts (SN1)
• 4× washers (M10)
• 2× washers M8 (W3)
• 4× leveling feet
Attaching adjustable leveling feet (see page 16)
No legs, center, only four leveling feet (M1) and washers (W1)
Overview of assemblies (see page 15)
Point 3 «Legs, center» is no longer applicable
Attaching the lower cross bar (see page 16)
Just two legs, on the right and the left
64
Appendix