Quilting frame assembly
> Place a washer (W3) onto a head cap screw (S2). Tighten the screw.
> Place the right-hand edge of the cross bar onto the lower longitudinal bar of the right leg in such a way
> Place a washer (W3) onto a head cap screw (S2). Tighten the screw.
Attaching the back bar
Required parts and tools:
• Cross bar, rear
• 8x slot nuts (SN1)
• Allen key no. 5 (T1)
Moving the upper longitudinal bar on the central leg
The upper longitudinal bar on the central leg must be moved so that the rear cross bar can be fitted.
> Use the Allen key (T1) to undo the two screws in the lower slot on the right and left of the front leg and
18
that the borehole is located precisely above the pre-fitted slot nut.
then push the longitudinal bar slightly forward.