Attachting Adjustable Levelling Feet; Attaching The Lower Cross Bar - Bernina Q 24 Manual

Quilting frame assembly

Attachting adjustable levelling feet

The adjustable levelling feet are used to level the quilting frame (see page 26). To ensure sufficient scope
for precision adjustment of the height, the levelling feet must not be screwed in as far as they can go.
Required parts and tools:
• Legs, center
• Legs, left
• Legs, right
• 6× levelling feet (M1)
• 6× washers (W1)
• Open-ended wrench no. 14 (T2)
> Place one washer (W1) on each levelling foot (M1).
> Screw one levelling foot onto each leg. To ensure that there is sufficient scope for precision adjustment

Attaching the lower cross bar

Required parts and tools:
• Cross bar, bottom
• Legs, center
• Legs, right
• Legs, left
• 3× head cap screws M8 × 50 (S2)
• 3× washers M8 (W3)
• Allen key no. 6 (T1)
Prerequisite:
•
16
of the height, set a distance of 5 cm (1.96 inches) between the lower edge of the profile and the lower
edge of the foot.
Leg length is set.