Attaching The Front Stand Profile - Bernina Q 24 Manual

Quilting frame assembly
> Position the V-wheel unit under the outer round hole, insert the screw from above and then tighten it.
> On the other side of the profile, position the V-wheel unit (P16) below the slot so that the distance from
> Insert the screw and washer from above, but only tighten the screw slightly so that the V-wheel unit can

Attaching the front stand profile

Machine damage due to undoing screws on the underside of the machine
NOTICE
Parts of the machine can fall out.
> Do not undo any screws on the underside of the machine.
Assembling the front stand profile
Required parts and tools:
• Stand profile, front (P1)
• Damping mat (P3)
• Circular sleeve (P5)
• Threaded bolt (P6)
• Spring washer (P7)
• Washer (P8)
• Head cap screw (P11)
• Washer, thick, small (P13)
• O-ring (P14)
• Washer, thick, large (P15)
42
the left-hand screw head to the right-hand screw head is approximately 28 cm (11 inches).
still be moved.