Bernina Q 24 Manual page 67

Just two head cap screws M8 × 50 (S2)
Just two washers M8 (W3)
Do not perform any steps in the instructions that affect the central leg.
Attaching the rear cross bar (see page 18)
• Just four 4× slot nuts (SN1) are required
• Do not carry out the tasks described in the instructions entitled «Moving the upper longitudinal bar on
the central leg».
• Work described in the instructions entitled «Positioning the rear cross bar»: Do not perform steps 1 and
2.
Step 4 new: «Insert the rear cross bar into the slot on the left leg in such a way that the inserted slot nuts
are located in the lower slot and point inward, and the "TOP" sticker faces upward. ....»
• Do not perform the work described in the instructions entitled «Fitting the rear cross bar on the central
leg».
Attaching the front cross bar (see page 21)
• No slot nuts required.
• Do not carry out the tasks described in the instructions entitled «Fitting the front cross bar on the central
leg».
Quilting frame levelling (see page 26)
Do not carry out the tasks described in step 2 or step 4 of the instructions.
Attaching the rear track (see page 27) | Attaching the front track (see page 29)
12× head cap screws M4×16 (S6) required.
Attaching the leaders (see page 55), (see page 56), (see page 57)
In the step entitled «Measure and then use a pencil to mark out a point 155 cm/61 inches to the left and the
right of the marked center», use the following values: 108 cm/43 inches.
Appendix
65