Fitting Rail Covers - Bernina Q 24 Manual

Checking the position of the Y safety brackets
> Move the machine forward and backward.
> Check whether the Y safety brackets (M14) brush against the wheels.
> If they do, pull the Y safety brackets approximately 1 mm away from the wheels.
> Check whether the wheels become jammed.
> If they do, undo the head cap screw (S10) slightly.
> Check whether the machine can be lifted off the carriage.
> If it can, move the Y safety brackets closer to the wheels.
Attaching X safety brackets
Required parts and tools:
• 2× X safety brackets (M15)
• 2× serrated lock washers M6 (W7)
• 2× button head screws Torx M6×12 (S9)
• Torx screwdriver (T30)
> Push the serrated lock washer (W7) over the button head screw (S9). Screw down one X safety bracket
(M15) vertically to the carriage in the center at the back.
> Push the serrated lock washer (W7) over the button head screw (S9). Screw down the second X safety
bracket (M15) vertically to the carriage in the center at the front.
Checking the position of the X safety brackets
> Push the machine along the entire length of the quilting frame.
> Check whether the X safety brackets (M15) brush against anything.
> If they do, undo the button head screw (S9) slightly.
> Check whether the machine can be lifted off the quilting frame with the carriage.
> If it can, tighten the button head screw (S9) further.

Fitting rail covers

The rail covers are used to prevent your fingers getting caught or trapped.
Required parts and tools:
• 4x rail covers (M12)
Quilting frame assembly
49