Bernina Q 24 Manual page 38

Quilting frame assembly
> Undo the four screws to align the carriage.
> Align the carriage so that it slides smoothly over the tracks along the entire length of the quilting frame
> Tighten the screws.
Attaching the park position magnet
Required parts and tools:
• Magnet, circular (M8)
• Rubber cap, black (M9)
• 1x head cap screw M8×40 (S1)
• Countersunk screw M4×45 (S5)
• Nut M4 (N1)
• Allen keys no. 2.5 and no. 6 (T1)
• Open-ended wrench no. 7 (T2)
> Push the countersunk screw (S5) first through the magnet (M8) and then through the rear hole. Position
36
and all wheels are in contact with the tracks at all times.
the nut (N1) from the other side and hold it in place with the open-ended wrench. Tighten the screw.