2.7 Tabletop positioning
Attaching tabletop brackets
Attach a total of eight metal brackets as supports for the tabletops, comprising four in the rear cross bar and
four in the front cross bar.
Required parts and tools:
• 8× metal brackets (M10)
• 8× countersunk screws M8×14 (S8)
• Allen key no. 5 (T1)
Carry out the following tasks for all metal brackets.
> Hold the metal bracket (M10) in front of a slot nut in the cross bar so that the screw hole is positioned
directly above the thread.
> Insert a countersunk screw (S8) into the screw hole and tighten it, but only to the point where the metal
bracket (M10) can still be moved.
Positioning tabletops
Required parts and tools:
• 14× felt strips (M11)
• 3× tabletops
• Allen key no. 5 (T1)
> Attach felt strips (M11) to all metal brackets (M10), including the pre-assembled ones on the legs.
> Attach two felt strips to the upper longitudinal bar of the central leg.
Quilting frame assembly
25