Bernina Q 24 Manual page 47

> Insert the two screws (P12) on the right and the left and tighten them using the Torx T20 screwdriver.
> Push the screw (P10) with the washer (P9) through the central hole from below.
> Align the stand profile so that the V-wheel unit which is fitted in the slotted hole is on the same side as
with the front stand profile (top or bottom).
> Use the T25 Torx screwdriver to screw the screw into the thread on the rear slot nut, but only tighten it
slightly so that the profile can still be moved.
> Check to ensure that the two heads of the screws (P12) are sunk in the slot on the underside of the
machine.
– The stand profile can still be moved, but not rotated.
> Move the stand profile so that the arrow tip printed on the machine profile touches the edge of the
aluminum plate (P4).
> Tighten the screw (P10).
Quilting frame assembly
45