Table of Contents
Advertisement
3.2
Warning symbols
Warning symbols shown below are indicated on the robots and controllers to alert the operator to potential hazards. To
use the OMRON robot safely and correctly always follow the instructions and cautions indicated by the symbols.
1.
Electrical shock hazard symbol
WARNING
TOUCHING THE TERMINAL BLOCK OR CONNECTOR MAY CAUSE ELECTRICAL SHOCK, SO USE CAUTION.
2.
High temperature hazard symbol
WARNING
MOTORS, HEATSINKS, AND REGENERATIVE UNITS BECOME HOT, SO DO NOT TOUCH THEM.
3.
Caution symbol
CAUTION
Always read the manual carefully before using the controller.
This indicates a high voltage is present.
Touching the terminal block or connector may cause
electrical shock.
This indicates the area around this symbol may become very
hot.
Motors, heatsinks, and regenerative units become hot during
and shortly after operation. To avoid burns be careful not to
touch those sections.
This indicates important information that you must know and
is described in the manual.
!
Before using the controller, be sure to read the manual
thoroughly.
When adding external safety circuits or connecting a power
supply to the controller, read the manual carefully and make
checks before beginning the work.
Connectors must be attached while facing a certain direction,
so insert each connector in the correct direction.
Instructions by this symbol
Instructions by this symbol
Instructions by this symbol
S-7
Advertisement
Table of Contents
