Mitsubishi Melsec-A Series User Manual page 164

APPENDICES
/MELSEC
Power on procedure:
1
)
Switch power on.
2)
S e t
CPU to RUN.
3)
Switch on the START switch.
4) When magnetic contactor (MC) comes in, output equipment
is powered and may be driven by
the
program.
1) Switch power on.
2)
Set CPU to RUN.
3)
When DC power is established, RA2 turns on.
4) When DC power reaches
loo%,
timer TM starts.
(Timer (TIM) should be
set
to the time required for the
DC
voltage to reach 100% of i t s value
after
RA2 turns on.)
5)
Switch on the START switch.
6) When the magnetic contactor (MC) comes in, the
output
equipment is powered and may be driven by the program.