Table of Contents
Advertisement
REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA A X - 1
d.
Installing square hole plate assembly (6-31)
o Apply Helicolube - Molycote mixed grease to the spring (6 - 30).
o Hook the longer arm of the spring (6 - 30) on the hole of the shaft
holder (6 -16).
o
Select one out of three holes on the square hole plate assembly (6-31)
and decide the force of resetting,
o
Setting it on the stopper, turn the spring about 120° to provide the
spring with a proper spring force.
o Match the plate (1 - 50) to the position shown in the right hand figure
from the exposure counter dial side, and install it with the screw
temporarily.
o Keep stopping the lever (6 -10) with the teg portion of the base
(2 - 58).
o
Match the projection of the gear (6 - 8) with the notch of the dial
plate (6-7), and install the dial plate (6 - 7) with Pliobond.
- 3 2 -
Hide quick links:
Advertisement
Table of Contents
