REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX -1
14-2 Wiring
o
Refer to the wiring diagram and perform wiring correctly.
o
Carefully arrange lead wires so that no lead wire is held between parts.
o
When the lead wire (7 - 16) extended from the CdS (5-4) is connected to
the E l l - 2 circuit assembly (2 - 7) by means of a soldering, apply silicon
rubber to guarantee the insulation after cleaning the soldered portion with
isopropyl alcohol.
When replacing the Si cell with a new one, be sure to disconnect the lead
wire at the Si cell side, and clean the connected portion after soldering.
- 9 4 -