FujiFilm Fujica AX-1 Repair Manual And Part List page 109

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX - 1
o Method to check M printed circuit board alone
o Checking ML magnet circuit
After winding up the film advance lever, apply voltage to terminals of the M printed
circuit board as shown above, and see if the mirror starts or not.
When the mirror starts, the condition is normal.
o Checking a j (3 magnet circuit
After winding up the film advance lever, apply voltage to terminals of the M printed
board as shown above, and see if the moving contact is held firmly or not.
When the moving contact is held firmly, the condition is normal.
3. When 1 and 2 above are completed but still defective or when it is found to be
unrepairable, replace the magnet, M printed circuit board or flexible printed circuit board
as applicable with a new one.
R = 1 ~ 1OKS2
OOOCI p
5 2a
GND (Body)
R = 1 ~10K
GND (Body)
- 1 0 6 -
I, Battery
4 V - 6 V
l e ^ l ^ Battery
Hi 4 ~ 6 V