REASSEMBLY. REPAIR AND ADJUSTMENT
FUJICA AX - 1
1 -13 Assembling base plate assembly (6 - 2)
a.
Check the shaft holder (6 -16) to insure that it is cauled in the position
shown in the right hand figure against the base plate (6 -11).
b.
Check the gears (6 - 21 and 6 - 24) to insure that they are installed
respectively on the shafts (6 - 22 and 6 - 25) correctly and they rotate
smoothly.
c.
Installing gear assembly (6-6)
o Place the spring (6-5) in the opening of the gear assembly (6 • 6).
o
Match the projection (stopper portion) of the gear assembly (6 - 6) to
the projection of the base plate (6 -11).
o Apply one end of the spring (6-5) to the hole on the holder (6-4).
o Turn the holder (6-4) and match the small hole on the holder with
the hole of the shaft holder (6 - 16).
NOTE:
o
After installing the holder (6-4), make sure that the gear assembly
(6-6) resets smoothly.
NOTE:
Before installing the holder (6-4), carefully examine which
surface is the top.
The gear assembly will not reset smoothly if the spring
(6-5) is tangled.
- 3 0 -