FujiFilm Fujica AX-1 Repair Manual And Part List page 49

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX -1
o. Set the gear (5-101) stationarily in the position where the metal fixture (5-32)
of the 2nd blind is matched with the metal fixture of the 1st blind, and install
the 2nd shutter blind gear assembly (5 - 80) in the position shown in the right
hand figure.
p. Loosen two screws (5 - 81), and finely adjust overlapped positions of the two
metal fixtures.
After completing the adjustment, apply Pliobond to the screws (5 - 81) to lock
them, and retighten the screws securely.
q. Set the intermediate gear assembly (5 -126) so that the mark on the intermediate
gear is positioned as shown in the right hand figure, and install the clutch gear
assembly (5 -118).
r. Hook the spring (5 - 117) on the position shown in the right hand figure.
s. Check the arm lever (5-116) to insure that it does not hold the spring.
NOTE: o If the arm lever (5-116) holds the spring, the clutch gear assembly
(5-118) does not return smoothly causing traveling velocity of the
1st blind to fluctuate.
o When shape of the arm lever (5 - 116) is improper, tooth position of
the clutch gear assembly (5 - 118) will be deviated, causing gear teeth
to collide when the film advance lever is wound.
o When winding up film successively, if the gear teeth collide, adjust
the arm lever (5-116).
- 4 6 -