FujiFilm Fujica AX-1 Repair Manual And Part List page 117

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX - 1
Section D
GENERAL: Before proceeding to the following inspections, make sure that:
(1)
(2)
1. Auto - winder
Check voltages on pins 1, 2, 19, 20, 21, and 22 of the HA16517, check the
parts, wiring and circuit related to these pins, and check the auto - winder contact
pin on the M printed circuit board.
PIN NO.
1
2
19
20
21
22
The auto - winder and strobo are connected to the camera
correctly.
Check the ST printed circuit board and self-timer switch for the
brush contact and set positions.
FOUNCTION
Shutter start input
Shutter start input
(with auto - winder
operated)
Auto- winder wind -
up
2nd shutter blind
start sginal
1st shutter blind
start signal
Mirror start signal
- 1 1 4 -
VOLTAGE AND OCCURRENCE
Refer to Section B - 1 .
L . . . . 0.9V or less
H. . . . .More than 0.9V
Shutter starts at edge of L
L 0.3V or less
H 0.7V or more
H is output for 30 msec. when 30 msec.
are elapsed after the 2nd blind starting.
Refer to Section B - 2.
Refer to Section B-2.
Refer to Section B - 2.
to H