Installing S3 Switch (2-63) - FujiFilm Fujica AX-1 Repair Manual And Part List

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJtCA AX - 1
d. Installing A -brush assembly (2 - 4) and S - brush assembly (2 - 2)
o
o
o
o
o
e.

Installing S3 switch (2-63)

Install the S3 switch so that:
o
o
Install them around the rewind spindle assembly (6-107).
Combine the A - brush assembly (2 - 4), insulation plate (2 -3), S - brush
assembly (2 - 2) and fix ring (2-1) in that order.
Install the fix ring (2-1) with the mat side faced upward.
Make sure that the brush moves smoothly.
Make sure that the brush is in firm contact with the printed pattern
of the E11 - 2 circuit assembly (2 - 7).
It turns off when the shutter is released.
It turns on when the shutter is charged completely.
With this switch turned off, the shutter cannot be released.
With this switch turned on, the shutter can be released.
When the film advance lever is turned in a half way with this switch
turned on, the shutter is released before winding up the film advance
lever completely.
- 9 2 -