Table of Contents
Advertisement
REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX - 1
NOTE:
When the camera does not operate correctly with an auto-winder
combined with the camera, the following simple method may be used
to check the camera and auto - winder.
Lens
Camera
Checking camera
o
(1)
Make sure that the lowded battery has a sufficient voltage.
(2)
Dismount the auto - winder.
(3)
Ground the auto - winder contact pin " b " on the camera (connect the
contact pin " b " to the camera body) after winding up the film advance
lever completely.
(4)
Now, depress the shutter releaie button deeply, and make sure that
the shutter does not start.
(5)
Next, with the shutter release button depressed deeply, unground the
contact pin " b " (disconnect the contact pin " b " from the camera
body), and make sure that the shutter starts.
Checking auto - winder
o
(1)
Make sure that the used battery has a sufficient voltage.
(2)
Set the switch to "CONT".
(3)
Apply voltage to the auto - winder from an externally located battery
as shown above, and make sure that the auto - winder starts. (Be
sure to connect a 1 to 10K
Bottom of the camera
Auto-winder contact pins
- 1 1 6 -
Battery
4.5 ~ 6 V
resistor as shown aobve.)
R
Camera contact pins
1 ~ 10K
Hide quick links:
Advertisement
Table of Contents
