4.
Flash operation
Check the strobo contact pin and contact first.
Next, check voltage on pin 26 of the HA16517, wiring for this pin and V
voltage.
PIN NO.
FUNCT1ON
Flash set input
26
6.
When 1 through 4 above are completed but still defective or when it is found
to be unrepairable, replace the flexible printed circuit board with a new one.
REASSEMBLY. REPAIR AND ADJUSTMENT
VOLTAGE AND OCCURRENCE
When the camera is in flash matic mode and
shutter speed is seelcted at 1/60 sec:
Normally:
- 1 1 9 -
FUJICA AX - 1
S F
0.3 V or less
0.7V or more