REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX -1
1-7
Installing base plate assembly (6 - 58)
a.
Apply Helicolube - Molycote mixed grease to the gear and shaft holding
parts.
b.
Install the lever (6-61) by matching its direction so that a locking can
be attained when the sprocket shaft assembly (6 - 80) is pushed down.
c.
Match the positioning pin (6 - 64) and other parts which are projected out
from the base plate (6 - 65) to the appropriate holes on the camera body
(6 - 88).
NOTE:
1.
When the base plate (6-65) is installed, it should not have
been floated. If the base plate is floated, the pin (6-81)
of the sprocket shaft assembly (6 - 80) does not engage with
the gear (6-83) sufficiently, and the pin may disengage with
the gear when advancing film.
2.
Those manufactured during the initial manufacturing period
may use a washer to hold the gear (6-83) on the camera
body and shape of long hole on the sprocket (6-79) may
differ from that on the recently manufactured sprockets.
These are to prevent idling of the sprocket.
- 2 2 -