Installing Neck Strap Eyelets; Installing Shaft (6 - 84); Sprocket (6-79) - FujiFilm Fujica AX-1 Repair Manual And Part List

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX - 1
1 - 4

Installing neck strap eyelets (6 -103)

Fit the two neck strap eyelets (6 -103) into the camera body (6 - 88), and
install them securely with two screws (6 -104) after applying Araldite to the
screws.
1 - 5

Installing shaft (6 - 84)

Apply Araldite to the threaded portion of the shaft (6 - 84), and screw the
shaft into the camera body (6 - 88) correctly.
1-6

Sprocket (6-79)

a. Check the sprocket shaft assembly (6 - 80) to insure that it is operated
smoothly by the spring (6 - 96).
b. Check the screw (6 - 78) to insure that it is securely tightened.
NOTE:
c. Description for operation of film advance system at. the time of multiple
exposures
When the sprocket shaft assembly (6 - 80) is pushed down hard (in other
words, when the film rewind button (1 - 78) is pushed down deeply), the
pin (6-81) comes into contact with the main body of the sprocket shaft
assembly (6 - 80). Thus, the sprocket shaft assembly (6 - 80) no longer
rotates. For this reason, when the film advance lever is wound up with
the film rewind button (1-78) pushed deeply, the sprocket (6 - 79) does
not rotate but the shutter is charged. Consequently, both the film and
exposure counter are not advanced, permitting the camera to make a
duplicated exposure on the same picture frame.
NOTE:
Be sure to tighten the screw at the side where a spot facing
has been made on the sprocket shaft (6-82).
When depth of the hole on the dicast body is excessive, the
sprocket will not be stopped even if the film rewind button is
pushed from the outside of the top cover.
- 2 0 -