Settings Of Connection With Gx Simulator - Mitsubishi CR750-Q Series Instruction Manual

14.5. Settings of Connection with GX Simulator

It is possible to connect with GX Simulator to simulate signal exchanges between the virtual controller in
MELFA-Works and a PLC (represented by GX Simulator).
CAUTION
GX Simulator versions
Currently, MELFA-Works support GX Simulator Version 7 only.
To connect with GX Simulator, define GX Simulator devices and assign the signal numbers of the robot
controller according to the following procedure.

Click the [Edit] button after enabling the [Connect GX Simulator] radio button to set definitions. The
Communication Setting with GX Simulator window appears.

Select the [Series] and [Type] of a device set in GX Simulator.

Add an I/O wiring definition with GX Simulator.
Click the [Edit] button at the bottom of the definition list on the side to be defined to display the setting
dialog box.
To change an already set definition, select it in either of the lists and click the [Edit] button.
Alternatively, double-click it in the list to achieve the same effect.
Fig. 14-9 Communication Setting with GX Simulator Window
73