Mitsubishi CR750-Q Series Instruction Manual page 3

Thank you for purchasing the MELFA-Works software package for Mitsubishi Electric industrial robots.
MELFA-Works is an add-in tool for SolidWorks that can be used to simulate Mitsubishi Electric industrial
robots. Using MELFA-Works, it becomes possibloe to verify robot program operations and creat processing
path data. This manual describes how to perform these operations.
This product requires SolidWorks. Please note that SolidWorks needs to be provided by the customer. Refer
to "2.1 Operating Environment" for supported versions.
Symbols Used in This Manual
DANGER
WARNING
CAUTION
No part of this manual may be reproduced by any means or in any form without prior consent

from Mitsubishi.
The details of this manual are subject to change without notice.

An effort has been made to make full descriptions in this manual. However, if any

discrepancies or unclear points are found, please contact Mitsubishi.
Microsoft, Windows are registered trademarks of Microsoft Corporation in the United States and other countries.
Adobe and Acrobat are registered trademarks of Adobe Systems Incorporated.
SolidWorks are registered trademarks of SolidWorks Corporation in the United States.
Other company names and product names are trademarks or registered trademarks of the respective companies.
Copyright(C) 2008 MITSUBISHI ELECTRIC CORPORATION
INTRODUCTION
Indicates that incorrect handling is likely to cause hazardous conditions
resulting in death or severe injury to the operator.
Indicates the possibility that incorrect handling might cause hazardous
conditions resulting in death or severe injury to the operator.
Indicates that incorrect handling might cause hazardous conditions resulting
in material damage or injury to the operator.
3