Mitsubishi CR750-Q Series Instruction Manual page 71


The signal definition is added to the list.
It is judged whether the set definitions are met or not in order from the top of the list.
However, the initial execution definition is only output once when simple simulation is started (before
normal simulation).
Item
Add Adds a simulation definition.
Select a row and click the [Add] button to use the setting values of the selected row as the
default values for the new definition.
Edit Changes a simulation definition.
Select a row and click the [Edit] button.
Delete Deletes the definition of the selected row.
It is also allowed to select multiple rows to delete them at once.
Move the definition of the selected row up or down.
It is also allowed to select multiple rows to move them at once.
Load Loads simulation definitions from MELFA-Works project files.
Please be careful when performing this operation; current definitions displayed in the list
will be cleared.
Save Saves the current simulation definitions in project files of MELFA-Works.
CAUTION
Be sure to stop the simulation before changing definitions.
During simulation, it is possible to check definitions, but it is not possible to add, change, delete or
load definitions. Stop the simulation before performing these operations.
"(bin)" in the [Status] column indicates that the
signal status is expressed as a binary number.
Disable a check box to invalidate the
corresponding definition during I/O simulation.
Fig. 14-6 Defined Simulation Conditions
Table 14-1 Details of Operations in the Dialog Box
71
Explanation