Effect I/O - Korg Krome Parameter Manual

Effect I/O

To achieve the best tonal quality, signals sent to the effects
should be at the maximum level below clipping. Also, use
the Wet/Dry parameter for the Insert Effects, Total Effect and
the Wet/Dry or Return 1, 2 parameter for the Master Effects
to adjust the effect output level.
If the input level is too low, the SN ratio may decrease.
On the other hand, if the input level is too high,
clipping may occur.
The following table shows the parameters related to the
level settings:
Program mode
OSC 1/2 Volume, Drum Track Volume (P0)
OSC1/2 MS1, 2, 3, 4, 5, 6, 7, 8 Level (P2)
Filter1/2 Trim (P3)
Filter1/2 Output (P3)
Input Driver1/2 Drive (P4)
Amp1/2 Amp Level (P4)
EQ Input Trim (P4)
Send1/2 (P8)
Effect Trim parameter
Effect Wet/Dry parameter (P8, P9)
Output Return1, 2 (P9)
Master Volume (P9)
Combination mode/Sequencer mode
Volume (P0)
Timbre/Track EQ Input Trim (P2)
Input
Send1/2 (P8)
Effect Trim parameter
Effect Wet/Dry parameter (P8, P9)
Output Return1, 2 (P9)
Master Volume (P9)
*1
Some effects may not have these parameters.
*1
(P8, P9)
*1
(P8, P9)
Overview Effect I/O
239