What You Will Find In This Chapter - Agilent Technologies E7474A Getting Started Manual

NOTE
Verifying the System

What You Will Find In This Chapter

What You Will Find In This Chapter
There are four methods you can use to verify your system. These methods are:
Method Additional Information
1 "Method 1: Using a Signal Generator" on page 137
2 "Method 2: Measuring a Known Channel in the System" on page 144
3 "Method 3: Measuring the Noise Floor" on page 147
4 "Method 4: GPS Measurement Verification Procedure" on page 152
If you have a phone-only system, use method 4 to verify your system. If you
have an digital receiver as part of your system, you need to use at least 2
Agilent
methods. These are method 4 and either method 1, or 2, or 3. Method 1 and 2
provide the highest level of confidence. Method 3 should only be used if you
do not have a signal generator and there is no known channel in the system.
•
The verification tests are only used to alert you to possible non-operating
conditions. To measure actual receiver specifications, the unit must be
measured in a controlled environment, using Agilent Technologies'
prescribed measurement techniques.
•
Before you start the verification procedures, familiarize yourself with the
system, by completing the online tutorial. See
Tutorial" on page
136
123.
"Using the Online
Agilent Wireless Solutions