Cluster Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R
Use these commands to configure cluster management.
10.1 Command Summary
The following section lists the commands for this feature.
Table 29 cluster Command Summary
COMMAND
show cluster
cluster <vlan-id>
no cluster
cluster name <cluster name>
show cluster candidates
cluster member <mac> password
<password>
show cluster member
show cluster member config
show cluster member mac <mac>
cluster rcommand <mac>
no cluster member <mac>
Ethernet Switch CLI Reference Guide

Cluster Commands

DESCRIPTION
Displays cluster management status.
Enables clustering in the specified VLAN group.
Disables cluster management on the Switch.
Sets a descriptive name for the cluster.
<cluster name>: You may use up to 32 printable
characters (spaces are allowed).
Displays candidates in the specified VLAN group.
Adds the specified device to the cluster. You have to specify
the password of the device too.
Displays the cluster member(s) and their running status.
Displays the current cluster member(s).
Displays the running status of the cluster member(s).
Logs into the CLI of the specified cluster member.
Removes the cluster member.
10
M P
E 3
C 13
C 13
C 13
E 3
C 13
E 3
E 3
E 3
C 13
C 13
49