Option List; Memory Modules; Removing Memory Modules - IBM RS/6000 44P 170 Installation Manual

Option List

v Removing Memory Modules, see page 30.
v Installing Memory Modules, see page 32.
v Removing the Processor Card, see page 34.
v Installing the Processor Card, see page 35.
v Removing Adapters, see page 36.
v Installing Adapters, see page 38.
v Internal Drives, see page 40.
v Removing Disk Drives, see page 42.
v Installing Disk Drives, see page 43.
v Configuration or Unconfiguration of Media Drives see page 41.
v Removing a CD-ROM Drive, Tape Drive, Diskette Drive, see page 45.
v Installing a CD-ROM Drive, Tape Drive, Diskette Drive, see page 45.
v Using Optional Media, see page 46.
v Installing Optional Media, see page 48.
v Installing the Optional Media Fan Assembly, see page 49.
v Performing System Firmware Updates, see page 51.

Memory Modules

Before performing these procedures, read "Safety Notices" on page vii. Use the
following steps when removing or installing memory modules.

Removing Memory Modules

Note: Memory modules are located on the system board. You can want to lay the
30
44P Series Model 170 Installation Guide
machine on its side for easier access to the modules.
1. Shut down the system as described in "Stopping the System Unit" on
page 22.
2. Unplug the power cable.
3. Remove the left side cover as described in "Removing the Left Side Cover"
on page 23.
4. Remove the cover support bridge as described in "Removing the Cover
Support Bridge" on page 26.
5. Before handling any card, board, or memory module, use one hand to touch
any metal surface of the chassis to minimize static electrical charges.