Ricoh PJ WX4152 Field Service Manual page 46

2. Installation
• Use the RGB cable provided with the projector.
• You can also use the Computer In/Monitor Out port to input RGB signals if [Computer 2
Terminal] in [Default Settings 2] is specified as [Input].
Using an HDMI cable
Connect an HDMI cable to the HDMI ports of the projector and the computer.
Using a DVI-to-HDMI cable
To input a DVI signal to the projector, connect a DVI-to-HDMI cable to the HDMI port of the
projector and to the DVI output of a computer. To output audio from the speaker on the projector,
connect an audio cable to the Audio In port of the projector and to the audio output of a computer.
• You can use a DVI-to-HDMI conversion adapter instead of a DVI-to-HDMI cable.
Using an Ethernet cable (PJ WX4152N/WX4152NI)
Connect an Ethernet cable to the Ethernet interface of the projector and to a network device such
as a hub. To use the projector via a network, you must specify settings such as the IP address.
• Use an Ethernet cable that is shielded.
44