Omron EQUO Series User Manual page 93

Display
UILCK Sensor mode changing
E2800 failure
NO SD No SD memory card
E3000 inserted
SDLOC Write-protected SD
E3002 memory card
SD ER SD memory card
E3003 recognition error
RESTR
Invalid setting file data
E5000
BCKUP
Setting file writing failure
E5001
RESTR Setting file reading
E5002 failure
HARD
E8100,
E8101,
Hardware error
E8102,
E8103,
E8104
If an error not listed above occurs, it may be caused by the wrong wiring. Turn OFF the unit
and check the wiring again.
Description
Failed to enter setting change mode of the air
flow sensor (D6FZ-FGT) to be changed.
Hold the MODE key for at least 3 seconds to
cancel the error, and switch to RUN mode by
MODE key of the air flow sensor. Mode of the
Air Flow Station needs to go back to RUN
mode, too.
An SD memory card is not inserted. Insert a
writable SD memory card.
Hold the MODE key for 3 seconds or more to
cancel the error display.
The SD memory card is write-protected.
Replace it with a writable one.
Hold the MODE key for 3 seconds or more to
cancel the error display.
Failed to recognize the SD memory card.
Insert a normal SD memory card.
Hold the MODE key for 3 seconds or more to
cancel the error display.
The setting data in the SD memory card is
invalid e.g. an invalid model type or setting
values.
Hold the MODE key for 3 seconds or more to
cancel the error display.
Failed to write setting files to the SD memory
card due to no free space or the card being
write-protected. Insert a writable SD memory
card.
Hold the MODE key for 3 seconds or more to
cancel the error display.
There is no setting files contained in the SD
memory card. Replace it with an SD memory
card with setting files.
Hold the MODE key for 3 seconds or more to
cancel the error display.
There may be a failure on the hardware.
Please contact the distributor or OMRON
representative office. The displayed error code
is required for identifying the problem.
6-3
6.Appendix
Troubleshooting