Omron EQUO Series User Manual page 72

(11) Writing the Setting Data (BCKUP)
Saves the Air Flow Station unit setting data in an SD memory card as a backup.
Operation:
Insert an SD memory card and hold the SET/REC/STOP key.
Saving is complete when "DONE" is displayed.
The process standby display appears and initialization starts after the process is
complete. If the key is released before the process is complete, initialization is
cancelled.
Important
Only one setting data item (the setting data for only one unit) can be stored in a single SD
memory card as a backup. If an SD memory card containing an already-saved setting
data backup is used, the setting data in the card is overwritten. The same applies to a
backup performed on other Air Flow Station units: the data is overwritten.
Note
・The setting data is written into the SYSTEM folder in the SD memory card.
・Setting data writing is not possible when ETC is set to "OFF".
・Air Flow Sensor settings are not backed up.
(12) Setting Clock (CLOCK)
Specifies if the internal clock setting is required.
The range of selection (Options):
OFF / DISP
Initial value: OFF
Setting Value
OFF
DISP
Note
・The CLOCK setting is not possible when ETC is set to "OFF".
・The CLOCK setting returns to "OFF" when the unit is reset.
Time setting is not available.
The IP item is displayed when the ▽ key is pressed after the setting
is applied with the SET/REC/STOP key.
Time setting is available.
The YEAR item is displayed when the ▽ key is pressed after the
setting is applied with the SET/REC/STOP key.
4-10
4. Setting (Air Flow Station Operation)
Operation