Omron EQUO Series User Manual page 47

(3) Changing IP Address
The following shows the procedure to change the factory default "192.168.0.20" to
"192.168.0.21".
Display
(Upper/Lower)
IP
DISP
↓
▽or △ Key
IP 1
192
↓
▽ Key
IP 2
168
↓
▽ Key
IP 3
0
↓
▽ Key
IP 4
20
↓
SET/REC/STOP Key
IP 4
020
↑Blinking
↓
▽or △ Key
IP 4
021
↑Blinking
↓
SET/REC/STOP Key
IP 4
21
↓
▽ Key
Check that SUB1 to SUB4 are set to 255, 255, 255 and 0 respectively and apply them
in the same way as the procedure above.
After the settings for IP 1 to IP 4 and SUB1 to SUB4 are completed, press the MODE
key.
"RESET" is displayed and the unit resets itself after the MODE key is pressed again and
THR mode is exited..
Display the first segment of the IP address. Press the ▽ or △
key until "P 1" appears at the upper row.
Check that "192" is displayed at the lower row, and press the ▽
key.
If "192" is not displayed, change the value referring to the changing
"IP 4" example shown later.
Check that "168" is displayed at the lower row, and press the ▽
key.
If "168" is not displayed, change the value referring to the changing
"IP 4" example shown later.
Check that "0" is displayed at the lower row, and press the ▽ key.
If "0" is not displayed, change the value referring to the changing
"IP 4" example shown later.
Press the SET/REC/STOP key to change the value displayed at
the lower row to "21".
The value starts blinking. Press the ▽ or △ key to change the
value to "21".
Press the SET/REC/STOP key to apply the value. Blinking stops.
To check or change the subnet mask, press the ▽ key to display
"SUB1" at the upper row.
3-15
3. Check and Preparation
Operation