Note
・Air Flow Sensor and Air Flow Station units do not have a power switch. They start
operation immediately when the power is supplied.
・ Be sure to stop the power supply to change the number of the connected Air Flow
Sensor units.
(5)
Checking Operation
When the power is supplied, the type name and version are displayed on the display section
for a while. The air flow rate information appears on the display, after the unit checks the
connection with Air Flow Sensor units.
Press ▽ or △ keys to change the display while the "RUN" indicator at the bottom of the
display is ON.
(Refer to "5.3 Screen Transition in RUN Mode")
Important
・Do not touch any front keys until the air flow rate appears on the display after the power
is supplied.
・5 seconds or more waiting time is required until the air flow rate information appears,
since the Air Flow Sensor and Air Flow Station require time to start up.
・The "ALLOK" indication appears when the unit normally recognizes all the connected Air
Flow Sensor units. If the connection is not normally recognized, investigate the cause
by checking wirings, DIP SW setting, ID setting, the number of the connected Air Flow
Station units, or other related issues.
・If a communication failure such as "no response" occurs on multiple Air Flow Sensor
units, after checking the connected unit, the unit with the smallest ID is displayed as
"NGnn" ("nn" stands for the Air Flow Sensor ID).
・The Air Flow Station factory default setting of the number of connected Air Flow Sensor
units is set to "one". To change the number of units, refer to "3.5 Setting the
Measurement Conditions".
・ When operating D6FZ-FGT by the key, select RUN mode on the Air Flow Station.
If the Air Flow Station is in FUN-mode or THR-mode, D6FZ-FGT
are not available and D6FZ-FGT
When setting the Air Flow Station in FUN-mode and THR-mode, be sure that this
・
product is in RUN-mode. If this product is set in FUN-mode or THR-mode, "REMOTE" is
not displayed and "Error" is displayed on the Air Flow Station.
・ In order to cancel the Error, press the MODE key for more than 3 seconds. And change
settings, set D6FZ-FGT in RUN mode and then set the Air Flow sensor in RUN
mode.
'
s main display shows "REMOTE".
3-8
3. Check and Preparation
's
key operations