Changing Air Flow Sensor Set Value - Omron EQUO Series User Manual

4.2.6 Changing Air Flow Sensor Set Value

This section explains the procedure to change Air Flow Sensor set values.
Follow the steps below.
(1) Display the ID of the target Air Flow Sensor unit in RUN mode.
(Refer to "5.3 Screen Transition in RUN Mode" for details of the operation procedure.)
Display
(Upper/Lower)
01.F01
Integrated Standard
Flow Rate
("RUN" Blinking)
↓
Hold △ Key
Display
(Upper/Lower)
03.F01
Integrated Standard
Flow Rate
(2) Switch the mode to FUN mode and set NN.SET to "DISP".
Display
(Upper/Lower)
CYCLE
1s
("FUN" Blinking)
↓
▽or △ Key
Display
(Upper/Lower)
NN.SET
OFF
↓
SET/REC/STOP Key
Display
(Upper/Lower)
NN.SET
OFF
↑Blinking
↓
SET/REC/STOP Key
Display
(Upper/Lower)
NN.SET
DISP
↑Blinking
Press the MODE key repeatedly until "RUN" starts blinking.
The Air Flow Sensor unit ID and measured value code is displayed
at the upper row.
The measured value is displayed at the lower row. The integrated
standard flow rate is displayed here.
A long press of the △ key switches Air Flow Sensor unit IDs. Hold
the key until the ID of the target unit appears.
For example, display "03" as the ID.
Press the MODE key repeatedly until "FUN" starts blinking.
(The status indicator of the ID03 Air Flow Sensor blinks in yellow
when the unit enters FUN mode.)
"CYCLE" is displayed at the upper row.
Press the ▽ or △ key to display NN.SET.
Press the SET/REC/STOP key. The set value at the lower row
starts blinking.
Press the ▽ or △ key to display DISP, and then, press the
SET/REC/STOP key.
The setting is applied when DISP stops blinking.
4-16
4. Setting (Air Flow Station Operation)
Operation
Operation
Operation
Operation
Operation
Operation