Omron EQUO Series User Manual page 37

< D6FZ-FGT>
By the key operation of the Air Flow Sensor, it is possible to
resister.
The Unit No. and Termination resister is set in the FUN mode on
(1) Setting of the communication setting
In order to set communicati on setting, display the communication setting in
FUN mode.
[1] Press MODE Key and select FUN mode.
[2] Press SELECTION Key (UP - DOWN Key) until "SER" is displayed.
[3] Then Press SET Key, Press SELECTION Key until "DISP" is displayed.
And press SET key again.
(2) Setting of the Unit No.
[1] Select FUN mode by MODE Key.
[2] Press SELECTION Key until "U.No.
[3] Press SELECTION Key and set the Unit No. (01 to 08). Then Press SET Key.
(3) Setting of the Termination resister
[1]Select FUN mode by MODE Key
[2] Press SELECTION Key until "TER
[3] Press SET Key, and press SELECTION Key until "ON" is displayed.
Then Press SET Key.
01" is displayed. Then Press SET Key.
ON" is displayed. Then Press SET Key.
3-5
3. Check and Preparation
set the Unit No. and Termination
D6FZ-FGT
.