Avaya G250 Installing And Upgrading page 58

Configuring the G250
3. At the prompt, enter y to configure basic gateway connectivity.
Note:
If you enter n but then change your mind, you can use the script-config CLI
Note:
command to run the installation script, so long as you have not saved any
configuration changes you may have made.
4. You are prompted to configure the following parameters. For each parameter, you can
enter a value, or press Enter to accept the default value shown in square brackets:
- VLAN number
- IP address for the primary management interface
- Subnet mask for the primary management interface
- IP address for the default gateway (router)
- Up to four IP addresses to specify the Media Gateway Controllers
- Hostname for the G250
The settings you configured are displayed, and you are prompted for confirmation.
If you confirm the settings, they are saved and the G250 reboots.
●
If you do not confirm the settings, you are prompted to re-configure them. If you enter y,
●
the parameters are presented again for configuration.
5. Connect the Ethernet port to the network to enable remote access to the gateway. A
remote technician can now further configure the gateway using the CLI.
58 Installing and Upgrading the Avaya G250 Media Gateway