Upgrading The 4602Sw And 4602D Phones Example - Avaya G250 Installing And Upgrading

Hide thumbs Also See for G250:
Table of Contents

Advertisement

Upgrading IP phone configuration and firmware files
8. Copy the boot image files for up to two IP phone types.
- To copy from the remote FTP/TFTP server, use either the copy ftp phone-image
command or the copy tftp phone-image command for each IP phone type.
- To copy from the USB device, insert the USB device into the G250 USB port and copy
the files to the resident TFTP server using the copy usb phone-image command
9. Copy the phone application image files for up to two IP phone types.
- To copy from the remote FTP/TFTP server, use either the copy ftp phone-image
command or the copy tftp phone-image command for each IP phone type.
- To copy from the USB device, insert the USB device into the G250 USB port and copy
the files to the resident TFTP server using the copy usb phone-image command.
10. Enable the TFTP server to allow loading of the new files to the IP phones using the ip
tftp-server command.
11. Reset the phones and wait for the installation to be completed.
Note:
Once the upgrade procedure is complete, you can delete the files using the
Note:
erase phone-image command.

Upgrading the 4602SW and 4602D phones example

In the following example, 4602SW and 4602D phones, which use the same image files, are
upgraded.
1. Check the available memory size for the image files using the show
application-memory command. If the memory size is smaller than the combined sizes
of the image files for the phones, proceed to step 2, otherwise proceed to step 5.
2. Set the memory size for the image files using the ip tftp-server file-system
size command.
G250-001(super)# ip tftp-server file-system-size 11264
To change ip tftp-server file system size, copy the running configuration
to the start-up configuration file, and reset the device
G250-001(super)
3. Copy the running configuration to the start-up configuration using the copy
running-config startup-config command.
G250-001(super)# copy running-config startup-config
Beginning copy operation ................... Done!
84 Installing and Upgrading the Avaya G250 Media Gateway

Advertisement

Table of Contents
loading

Table of Contents