Upgrading G250 Firmware Using The Cli Via A Usb Device; Cli Commands For Upgrading G250 Firmware Via A Usb Device; Example Upgrade Using The Cli Via A Usb Device - Avaya G250 Installing And Upgrading

Upgrading the G250 firmware

Upgrading G250 firmware using the CLI via a USB device

You can upgrade firmware via a USB mass storage device using the CLI. The upgrade files
must first be downloaded to a local PC.
1. Prepare installation worksheets. See
2. Download the firmware files to a PC. See
PC on page 79.
3. Insert a USB mass storage device into the PC's USB port, and copy the firmware files to
the USB mass storage device.
4. Remove the USB mass storage device from the PC, and insert it into the G250 USB port.
5. Run CLI commands to copy the firmware files from the USB mass storage device to the
G250. See

CLI Commands for upgrading G250 firmware via a USB device

You can use CLI commands to upload an upgrade file from a USB mass storage device to the
G250. You must use the specific path to the file on the USB mass storage device.
Use the copy usb module command, followed by the slot number of the module you
●
want to upgrade, to upgrade the firmware on a media module from a USB mass storage
device.
Use the copy usb SW_imageA command to upgrade the G250 firmware into Bank A
●
from a USB mass storage device.
Use the copy usb SW_imageB command to upgrade the G250 firmware into Bank B
●
from a USB mass storage device.

Example upgrade using the CLI via a USB device

To upgrade the firmware of an MM312 media module in slot 3 from a USB mass storage device
where the upgrade file is located in the directory \temp\, use the following command:
copy usb module usb-device0 \temp\mm312v51.fdl 3
78 Installing and Upgrading the Avaya G250 Media Gateway
CLI Commands for upgrading G250 firmware via a USB device
Preparing installation worksheets
Downloading G250 firmware files to a local
on page 75.
on page 78.