Back-Up Lamp Switch; Removal; Installation; Differential - Chrysler Sebring 2005 Service Manual

21 - 20 T350 MANUAL TRANSAXLE

BACK-UP LAMP SWITCH

REMOVAL

(1) Lift vehicle on hoist.
(2) From bottom side of vehicle, disconnect back-up
lamp switch connector (Fig. 49).
Fig. 49 BACK-UP LAMP SWITCH
1 - CONNECTOR
2 - BACK UP LAMP SWITCH
(3) Unscrew switch from transaxle.

INSTALLATION

(1) Install back-up lamp switch. Teflon tape or
equivalent must be used on switch threads. Tighten
switch to 24 N·m (18 ft. lbs.) torque.
CAUTION: Do not overtighten switch.
(2) Connect back-up lamp switch connector (Fig.
49).
(3) Lower vehicle.
(4) Verify back-up lamp operation.

DIFFERENTIAL

DISASSEMBLY

(1) Remove differential bearing cones (ring gear
and diff. case side) using Tool C-293-PA, Adapters
C-293-45, and Tool 4996 (Fig. 50) (Fig. 51).
Fig. 50 Remove Differential Bearing Cone from Diff.
Case Side
1 - TOOL C-293
2 - TOOL C-4996
3 - TOOL C-293-45
4 - DIFFERENTIAL CASE
Fig. 51 Remove Differential Bearing Cone from Ring
Gear Side
1 - SPECIAL TOOL C-293
2 - SPECIAL TOOL ADAPTER C-293-45 (USE 4 PIECES)
3 - DIFFERENTIAL ASSEMBLY
4 - DIFFERENTIAL BEARING CONE
5 - SPECIAL TOOL C-4996 (NOTE POSITION)
JR