Shifter - Yamaha XZ550RJ 1982 Service Manual

3. Install the crankcase bolts. Tighten the bolts
in the tightening sequence shown in the il-
lustration. After all the bolts are tight, torque
them to specification. Torque the bolts in
the torquing sequence also shown in the il-
lustration.
Tightening torque:
Bolts #1 ~16(M6x1.0)
10 Nm (1.0m.kg, 7.2ft-lb)
Bolt/nut #17 (M10x 1.25)
30 Nm (3.0m-kg, 22ft-lb)
4. Tighten the engine-mounting-bracket secur-
ing bolts (#18, #19). Torque the bolts to
specification.
Tightening torque:
10 Nm (1.0m-kg, 7.2 ft-Ib)
NOTE:
Apply Yamaha bond #4 to bracket securing bolts
1. Lightly grease then lips of the shift shaft oil
seal at the leftside crankcase.
1. Shift shaft oil seal
2. Install the shifter into the right side crank-
case. Hook the shift-cam-stopper spring
beneath the projection in the crankcase. Be
sure the shift lever correctly engages the
shift drum pins.
NOTE:
Open the shift lever and the shift drum stopper so
they can clear the shift drum during installation.
74