Table of Contents
Advertisement
Printer Start-Up Options
The Administration/Startup Options menu allows you to configure
your printer to run certain options automatically when you turn it on.
Enabling/Disabling the Start-Up Page
By default, the printer prints a start-up page when you turn it on. The
start-up page lists basic information about the printer, such as its
name, the PostScript emulation level and version, and various printer
settings. However, you can turn the start-up page off to conserve
paper and toner.
Menu
Choices
Default
Notes
Enabling/Disabling the SYS\START File
If you have a hard disk and Do Sys Start is enabled, when the printer
is turned on, the controller checks the hard disk for a PostScript file
named SYS\START and executes this file.
Menu
Choices
Default
Notes
4-46
Administration/Startup Options/Do Start Page
Yes—Print a start-up page each time the printer is turned on.
No—Don't print a start-up page each time the printer is turned
on.
Yes
If you used the Administration/Engine/Inputbin x Name options
to change the names of the input bins, these names replace
Multipurpose, Lower, and Optional in the message window.
Administration/Startup Options/Do Sys Start
Yes—Check the hard disk for and execute the SYS\START file
when the printer is turned on.
No—Don't check the hard disk for a SYS\START file.
Yes
This file does not print. Information on creating a SYS\START
file is available in the QMS Crown Technical Reference Manual
(shipped on disk with your printer) and also via Q-FAX (see
appendix A, "QMS Customer Support," for information on
using Q-FAX).
QMS 1725E Print System Reference
Advertisement
Table of Contents
