QMS 1725E Reference page 152

3 Hold the new SIMM at a 45° angle with the notch on the left-
hand side. Slide the new SIMM into the open SIMM connec-
tor.
4 Tilt the SIMM up to a 90° angle until you feel it snap into
place.
5 Repeat steps 2 through 4 for each additional SIMM you are
installing.
6 Return the tray assembly to the printer by following the
instructions in “Re-installing the Tray Assembly,” earlier in
this chapter.
6-22
Notch
QMS 1725E Print System Reference