3
Snap the two plastic feet to the bottom side of the interface
board on the opposite end from the interface connection
Note: Your optional interface card may look different than the one
shown in the illustration.
4
Peel the tape from the bottom of the plastic feet
5
With the plastic feet facing down, insert the interface card
through the connector opening in the metal plate from the
outside of the tray assembly.
6
Using the two screws from the I/O plate you removed in step
2, mount the metal plate on the interface card to the connec-
tor opening.
»
Note: Your optional interface card may look different than the one
shown in the illustration.
Installing Optional
Interfaces
Printer Options
6-31