Table of Contents
Advertisement
Choices
Off—Reset PCL to its default state at the end of each PCL
print job, execute an implicit <ESC>E at the start and end of
the job, and delete any temporary fonts, macros, and patterns.
On—Reset PCL to its default state at the end of each PCL
print job. Temporary fonts, macros, and patterns from previous
PCL print jobs are retained in memory after the print job has
completed. You can recall these downloaded fonts, macros,
and patterns from within your PCL file without having to
download them again.
On Compatibility—Retain the entire state of PCL as well as the
temporary macros, fonts, and patterns from previous PCL jobs
unless you do one of the following:
Default
Off
Scalable Fonts
Specifies whether to enable or disable the printing of HP PCL5 scal-
able fonts by an application.
Menu
Administration/Emulations/HP PCL 5/Scalable Fonts
Choices
Enable—Allow selection of scalable fonts. When you print
PCL4 documents, PCL5 may substitute scalable fonts that
could cause your PCL 4 documents to print incorrectly.
Disable—Print using bitmap fonts only.
Default
Enable
Printer Configuration
n
Change any PCL front panel option
n
Send any PCL-specific DOC—except the emula-
tion DOC
n
Send any other DOC, such as number of copies,
duplex, orientation, or inputbin
n
Send a PCL job from a different communications
port—for example, if the PCL print environment is
set for PCL jobs to print from the parallel port, and
a PCL job is sent from the serial port. If any one of
these occurs, the PCL state is reset to the new
default, and the previous state is lost.
Emulations
4-33
Advertisement
Table of Contents
