Setting The End Job Mode Via The Control Panel - QMS 1725E Reference

your print queuing system documentation, your network administra-
tor, or your QMS vendor for more information.
Setting the End Job Mode via the Control
Panel
Use the following procedure to set the end job mode from the printer's
control panel for printers connected via the serial or parallel interface
to a stand-alone PC, a PC print server, or some other type of print
queuing system:
» Note: If you print both serial and parallel protocol jobs, then you must set
the end job mode for each protocol.
Wait for the printer to go idle, and then press the control panel keys in
the order shown in the following instructions to access the End Job
Mode option. The printer responds by displaying a status message in
the message window.
» Note: You may need to press the Next key one or more times to advance
through the list of selections or options.
Key
Online/
Offline
Menu
Next
Select
Next
Select
Next
Select
5-22
Purpose
Turns off the Online/Offline indicator and
readies the printer for configuration.
Accesses the configuration menu.
Advances to the Operator Control/
Administration menu.
Accesses the Administration menu
Advances to the Communications/Parallel
(or Serial) menu.
Accesses the Parallel (or Serial) menu.
Advances to the Parallel (or Serial)/End
Job Mode menu.
Accesses the End Job Mode menu.
QMS 1725E Print System Reference
Message Window
IDLE
CONFIGURATION
OPERATOR CONTROL
CONFIGURATION
ADMINISTRATION
ADMINISTRATION
COMMUNICATIONS
COMMUNICATIONS
PARALLEL ( or
SERIAL)
PARALLEL/SERIAL
MODE
PARALLEL/SERIAL
END JOB MODE
END JOB MODE
OPTION